Garelick 71053 MOTOR BRACKET User Manual download pdf

Mounting and Operating Instructions for

Outboard Motor Bracket Models 71040, 71057,

71042, and Outboard Motor Bracket Adapter

Plate Model 71053

Form 12.109

OUTBOARD MOTOR BRACKET MOUNTING INSTRUCTIONS

(See reverse side for Adapter Plate Installation Instructions)

IMPORTANT INSTRUCTIONS

Check hardware pack contents for the following mounting

hardware:

4 - 5/16 x 3" stainless steel carriage bolts

4 - 5/16" stainless steel locknuts

1. These brackets are not recommended for use with 9.9

4-stroke motors.

2. Read instructions completely before starting assembly.

3. Motor bracket must remain in “UP” position throughout

installation.

4. DO NOT operate motor bracket unless motor is installed

on bracket.

MOUNTING INSTRUCTIONS

Refer to Fig. 1

Measure the distance on your outboard motor between the

cavitation plate and the upper inside edge of the mounting

clamp. Subtract 2" from this length. Then add the total travel

distance of your model outboard motor bracket from the table

below to the distance measured on your motor.

Refer to Fig. 2

Mark this total length on a stick and tape it so that the top is

flush with the top of the mounting board of the motor bracket.

Choose the most appropriate side of your transom for mounting

the bracket. Position your bracket so it will not interfere with the

turning operation of your main motor or rudder.

Refer to Fig. 3

For Powerboat Installation: Take your outboard motor bracket

with the stick taped on and place the mounting flanges on your

transom. Position the bracket so the bottom of the stick is one

inch above the boat’s bottom at the centerline of the outboard

motor bracket.

Refer to Fig. 4

For Sailboat Installation: Take your outboard motor bracket

with the stick taped on and place the mounting flanges on your

transom. Position the bracket so the bottom of the stick is even

with the boat’s actual waterline.

FIG. 3

Write for

a Complete

Catalog

Phone: 651-459-9795

PO Box 8, 644 2nd Street E-mail: [email protected]

St. Paul Park, Minnesota 55071 On the Web: www.garelick.com

10/08

FIG. 1

MOTOR

WEIGHT NOT VERTICAL

MODEL H.P. RATING TO EXCEED TRAVEL

71040 TO 8 59 LBS. 8

⁄2"

71041 OVER 7

⁄2 TO 20 115 LBS. 11

⁄4"

71042 OVER 7

⁄2 TO 12 82 LBS. 14

⁄4"

71044 TO 30 135 LBS. 14

⁄4"

FIG. 2

FIG. 4

(over)

Transom Mounting Hardware NOT Supplied Due to Various

Transom Thicknesses.

Recommend 5/16" Stainless Steel Fasteners

1 2

Summary of Contents

Page 1 - Plate Model 71053

Mounting and Operating Instructions forOutboard Motor Bracket Models 71040, 71057,71042, and Outboard Motor Bracket AdapterPlate Model 71053Form 12.10

Page 2 - IMPORTANT CAUTION GUIDELINES

Refer to Fig. 5After the bracket has been properly positioned, mark the fouroutside hole locations using the bracket as a template on yourtransom (See

Comments to this Manuals

No comments

Garelick 71053 MOTOR BRACKET User Manual

Browse online or download User Manual for Accessories for water Garelick 71053 MOTOR BRACKET. Garelick 71053 MOTOR BRACKET User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Accessories for water Garelick 71053 MOTOR BRACKET