Garelick 48548 COCKPIT SIDE COAMING BOLSTER User Manual download pdf

Instructions for mounting

Model 48536 – 36" Length x 5" Height

Model 48548 – 48" Length x 5" Height

Cockpit Side Coaming Bolster – Premium White Quilted Vinyl

Form 12.506

Replace or add comfort and padded protection to inside

coaming wall area of any cockpit, especially fish boats!

Note: Before drilling any holes in your boat always check

paper template against back of bolster and make sure

pilot hole locations line up with centers of 1-1/4" holes in back

of bolster. When properly mounted, top of bolster to center of

mounting holes are approximately 2-1/4" and 2-3/4"

respectively as shown in Figure (1).

INSTALLATION

Secure either* 36" or 48" bolster to gunwale coaming as shown

in Figure (1) with use of paper template provided. Tape paper

template in desired position where bolster is to hang and mark

at point A of Figure (2) as shown, repeat for each hole desired

location. Attach upholstery clip (B) fasteners to boat surface.

Insert top edge of each clip into 1-1/4" hole on back of bolster

and push down and in place (See Figure (1)).

These bolsters are somewhat flexible by design and can be used

around moderate curved areas in your boat.

*Both sizes can be used or abutted up to each other to

accomplish desired coverage.

Mounting Hardware

3 (4) - 66.978 Upholstery Clips (B)

3 (4) - 03.168 #8 Screws

Write for

a Complete

Catalog

Phone: 651-459-9795

PO Box 8, 644 2nd Street E-mail: [email protected]

St. Paul Park, Minnesota 55071 On the Web: www.garelick.com

11/05

FIG. 1

FIG. 2

Instructions for mountingModel 48536 – 36" Length x 5" HeightModel 48548 – 48" Length x 5" HeightCockpit Side Coaming Bolster

No comments

Garelick 48548 COCKPIT SIDE COAMING BOLSTER User Manual